Setting the SMART MAC Target Network

The following procedure describes how to set the SMART MAC target network.

Procedure 109: Setting the SMART MAC Target Network

  1. Configure the SMART MAC nodes by setting the following attributes. You can use select station (generic traffic sources) or workstation (standard application models) models. Both models are MANET-capable.

    • Buffer size. Specify the same buffer size used on the learning network (in our example, that would be the Wireless LAN buffer size).
    • Transmission range. If a single collision domain with no mobility will exist in the network, make sure the transmission range is large enough for all nodes to reach each other. Otherwise, select a transmission range that ensures that multiple collision domains are created. If mobility is introduced, collision domains will change based on the transmission range of all nodes.
  2. Configure the SMAC configuration object.

    2.1 Set the expected (learned) throughput values in the contention table (from step 4 of Procedure 108). 2.2 Set the values for dropping probability (from step 4 of Procedure 108). They could have been obtained from the learning network as a function of the number of contenders. For this case, specify the values within the table). Alternatively, the values can be specified as unique values based on expected/theoretical results. For this case, specify the values in the top level attributes of the contention parameters. 2.3 Set the reachability update time according to the mobility of the network. For example, if the nodes in the scenario move very slowly, the reachability update should occur less often than it would in a faster network. 2.4 Enable hidden node collision detection if multiple collision domains have been set on the network (or will appear due to mobility).

End of Procedure 109