Model Interfaces

Packet Formats

The following table lists the packet formats used in the LAPB model suite.

Table 136: LAPB Packet Formats

Name Description
lapb_pk Models the data link frame. See the X.25 Recommendation for explanation of data link frame.
lapb_frmr_info Used by the special FRMR (frame error) response frame. It contains information that describes the error that caused the FRMR frame to be transmitted.

ICI Formats

The following table lists the interface control information (ICI) formats used in the LAPB model suite.

Table 137: LAPB ICI Formats

Name Description
lapb_req Used to pass information about the status of the link to the higher layer.

LAPB Primitives

LAPB communicates with the higher layer in the forms of primitives. These primitives deal with information concerning the link. The following table lists the primitives used by the lapb process model.

Table 138: LAPB Primitives

Name Description
OSIC_DL_CONNECT_REQUEST Higher layer informs the LAPB to initiate the link connection.
OSIC_DL_DISCONNECT_REQUEST Higher layer informs the LAPB to close the link connection.
OSIC_DL_CONNECT_INDICATION LAPB informs the higher layer that the link is connected.
OSIC_DL_DICCONNECT_INDICATION LAPB informs the higher layer that the link is disconnected.

LAPB Timers

LAPB uses a series of timers as defined by the X.25 Recommendation to control certain events. The following table lists the timers used in LAPB model suite.

Table 139: LAPB Timers

Name Description
T1 Length of time that a process will wait for a response before resending an information or supervisory frame.
T2 Length of time that a process may wait before initiating an acknowledgment frame. If an outgoing information frame is not available during this time, an appropriate supervisory frame will be generated.
T3 Length of time, without detecting any activity on the link, after which a process may conclude that the link is non-operational and thus close the connection.
max idle time Maximum length of time that a link between two LAPB processes can be idle. If a process has not sent a frame in this length of time, it will send a special LINK_ALIVE packet. If a process has not received a frame in this length of time, it will start the T3 timer to allow the LAPB protocol to detect an inactive link condition.

本站文档由 北京智网畅联科技有限公司 整理、翻译并提供 · Documentation compiled and provided by Beijing ZNetLink Technology Co., Ltd.

交流群 · QQ Group:OPNET/智网妙算网络仿真交流群(群号 486383494)

原文档 © 2017 Riverbed Technology · 本站为公益翻译,由 AI 辅助完成,请仔细甄别

Original documentation © 2017 Riverbed Technology. Community translation, AI-assisted. Contact: jiazequn@znetlink.com