Update Installation Procedures
You must do an update system installation to install Riverbed Modeler on a server workstation where an earlier release is installed. A server workstation with Riverbed Modeler already installed normally has a directory called the "installation directory". This directory has a subdirectory for each installed release of Riverbed Modeler.
The update installation will add a new release subdirectory to … \<install_dir> that corresponds to the new release. The new release will continue to use the existing license file and Riverbed Modeler execution permits will remain usable after installation.
To update from the previous Linux release, do the following procedure:
Procedure 7: Updating from a Previous Release (Linux)
Note: If you are prompted during installation to shut down license servers running on this host, answer Yes. If you did not shut down the license servers during installation, do the following steps:
-
Shut down the floating license supervisor by typing the following command at the command prompt:
op_license_util -license_server_kill -license_server <hostname> -license_port <port> -
Install the new release.
The install process is described in the Installation Instructions that come with the software.
End of Procedure 7